IPhone 7 plus is another stylist invention of the apple. This device is very delicate and sensitive. A slight collision of any hard thing with this device cause a great damage to you. The damage is done to the display screen. Therefore if your iPhone 7 plus fall incidentally or collide with an object due to which its display screen is damaged then don`t worry. We provide you the different methods through which you can easily get your iPhone 7s display screen replacement at home.
Spudger tool
Suction cup
Pentalobe screwdriver
Phillips #000 screwdriver
Tri-point Y000 screwdriver bit
Opening tool
You just need a new iPhone 7 plus display screen.
One thing you should keep in mind that power off your iPhone whenever you do any repairing operation.
Remove the screws that are placed at both sides of the dock connector. Use the pentalobe screwdriver to remove them.
Then place the suction cup on the screen and pull it upward carefully in order to release the screen from the bottom of the body.
Now use the pointed side of the spudger tool and try to loosen the screen from the bottom of the iPhone 7.
Then slight the inserted flat end of the spudger tool to widen the gap between the display screen and the body of iPhone 7.
Again slight the spudger toll at the left and right side of the screen to open the screen from all the sides.
After doing this pull the suction cup to open the screen accurately.
Remove the suction cup.
Now further insert the opening pick at the place of spudger tool to break all the remaining adhesive completely.
Now open the display screen from the left hand side as you open the cover of your iPhone
Now remove the four tri-point Y000 screws that are placed on the bracket of the lower connector by using a tri-point Y000 screwdriver.
Remove that bracket and place it safely aside.
Now use the pointed side of the spudger tool to lift the battery connect out from its housing on the logic board.
By using the finger nail or the pointed side of the spudger tool pull the two lower display connector from the logic board.
Now by using the tri-point Y000 screwdriver remove the three screws that are placed on the bracket of front panel sensor assembly connector.
Remove the bracket.
Remove the front panel sensor assembly connector from the logic board
Now remove the five screws that are placed on the earpiece speaker bracket by using the Philips #000 screwdriver.
Remove the bracket.
By using the flat end of the spudger tool pull up the front facing camera and bend the cable of the camera in order to make the place for earpiece speaker.
Remove the earpiece speaker.
In order to operate with the bottom components bend the camera and its ribbon at the bottom side of the iPhone 7 plus.
Remove the proximity sensor by using the spudger tool.
Again by using the spudger tool remove the light sensor from its place.
Now insert the flat side of the opening tool under the camera cable and pull it to separate the cable from its corner.
At the corner of the separated cable place the spudger tool and remove the whole cable.
Now disconnect the front camera and sensor cable assembly.
Now remove the four screws that are placed on the bracket of the home button by using the Y000 screwdriver.
Remove the bracket.
Now place the spudger tool`s flat end at the left corner side of the cable connector and pull it from its socket.
Similarly, pull up the underlying connector and disconnect it from the home button or touch id sensor.
Now remove all the adhesive that connects the touch id sensor cable to back side of the display panel by using the opening pick.
Now the next step is to remove the touch id sensor from the front side of the display screen and placed it to the new display panel of the iPhone 7.